This article wrote by DLICAN UV flatbed printer manufacturer, and we sincerely hope the following points can help all readers.
- Short-term maintenance (Around 3 days)
When the holiday Dlican UV flatbed printer dose not work within 3 days, the maintain steps as follows:
- Take a piece of foam board with similar size to the baseboard of machine head and wrap the foam board surface with cling film.
- Apply a dust-free cloth on the foam board surface and moisturize the surface with moisturizer. If the machine stop to work for a quite long time, you can put a little bit more moisturizer than usual.
- Put the wet foam board on the waste ink tank tray, and use the RIP software to control the car lifting then motor screw pole falling slowly, so that the print head surface and dust-free cloth fully contact (Do not press too tightly, just contact is fine).
- Close the uv flatbed printer and reset all function switches.
2.Medium-term maintenance (Around 3-15days)
If the machine will stop to work for 3days to half month, the maintenance should be do better.
The steps as follows:
(a) Firstly, please make the ink valve switch to the vertical state(Iron column up)
(b) Remove sealant head at top of the ink valve, using a syringe to attach a 6*4mm ink tube or windpipe to extract the cleaning fluid to wash the inside ink of print head. Firstly, open the plug cover of the ink discharging pipe to wash the inside of print head, and then screw the plug cover well and wash the nozzle of print head until the liquid is transparent from the print head. (Note! Pressure should not be too high,see print head surface with ink dripping out is enough, otherwise, too much pressure will damage the print head.)
(c) After washing, use a syringe to draw air out. Washing out all the cleaning liquid in the print head.( Note! Firstly, unscrew the plug cover and rinse the inside of print head. And then screw on the cover to rinse the nozzle of print head.)
(d). Use the syringe to draw a proper amount of moisturizing liquid, and slowly inject it into the print head until the nozzle has a moisturizing liquid flowing out.
(e). Close the ink valve normally, leaving the moisturize in the print head.
(f). Then follow the method of 1 to moisturize the print head normally.
(g). Turn off the emergency stop switch, turn off the computer and turn off all circuit switches.
Shenzhen Dlican Digital Technology Co., Ltd
Whatsapp/wechat/MP.:008618194085012 QQ:3454623752 Wechat:dlicanUVprinter
Factory Add.Building A, Huifengjin Industrial Park, Beihuan West, Shajing Street, Baoan District, Shenzhen, China. 518104